How Do I Install LED Non-Corrosive Batten Fittings?

Installation typically involves the following steps:

Mounting:

Secure the fitting using the supplied brackets and screws.
Ensure the fitting is level and mounted on a suitable surface, such as a ceiling or wall.
Make sure the mounting location is stable and can support the weight of the fitting.

Wiring:

Access the terminal block by removing the diffuser cover and LED tray.
Connect the mains wiring to the terminal block, ensuring the following connections:

Live (Brown)
Neutral (Blue)
Earth (Green/Yellow)

Use appropriate cable glands to maintain a waterproof seal and avoid strain on the wiring.

Double-check all connections to ensure they are secure and correctly positioned.

Sealing:

Check that all seals and gaskets are correctly in place before reassembling the fitting.
Tighten any screws and clips to maintain the IP65 protection rating, ensuring no gaps are left that could allow water or dust to enter.

Testing:

Restore power and switch on the fitting to ensure it functions properly.
Inspect the fitting for any signs of flickering or loose connections.

For detailed installation instructions and safety guidelines, always refer to the manufacturer's manual. We recommend professional installation to ensure safety and compliance with electrical regulations.